I know this is no big deal but on the rack I had it took some modification. I had to use a hack saw on the welds that hold my vertical bars to the rear cross bar. The mount on the base of the flag holder was big enough around that the welds was keeping it from seating good. I took the hack saw blade to each inside weld that the mount was up against. That did the trick.
Here are a few pics. Here is the rack I have.

Here is it is with the Flag installed. You can see the big welds on the other bars.

Here are a few pics. Here is the rack I have.

Here is it is with the Flag installed. You can see the big welds on the other bars.


Comment