Andrews 54 cams?

[pro50]

has anyone tried these new cams for the 96" yet? they are a easy swap desighned to use all stock components. take off tank and rocker covers and loosen rocker , flip to side take out stock push rods and mark where they go. steve at fullsac tells me there is a tool he will send me with cams that is a wire with a magnet (if i understood him correctly) you drop in pushrod hole to the lifter and pick it up out the way and hook wire over rocker housing giving enough room to remove cams and install the 54's. so all you need is rcker gaskets, cam cover gaskets and cams. this can be done for under $300.00 if installed yourself. this is what i plan to do to my 08 sg in a month or 2. anyone have experience with any of this?

dave, whats your take on this

[DevilDog]

I am curious in this also.....

[pro50]

where is crossville tn ddb? was in tn last thurs. thru mon. around pigeon forge and townsend and around.

[DevilDog]

its on I40 about an hour west of Knoxville..... You were close.

[pro50]

im goint to have to start asking if anyone is in the areas i am goint to from now on. i really want to go back up there with the bike. haven't been up there on a bike since 04 on my old duece and stayed a week and had a blast. new wife want to go so i'm sure it's in the near future.

[DevilDog]

This entire state has some of the nicest roads for bike riding. Very well maintained and some of the nicest scenery that you could ask for.

[CLL375]

Here's a quick how-to on swaping cams. http://www.fuelmotousa.com/cams.htm I've helped out a few friends with their cams before and the one thing I always do even if they say "I wont need them" is replace the cam bearings. The swap is very strait forward. Just take your time and it will be worth it.

[CLL375]

Oh, the write up is at the bottom of the page.

[pro50]

Thanks for that link cll375. been on that sight before when looking at woods cams but did'nt read that part.
thanks again, todd

[pro50]

yea ddb, i love riding anywhere up there.

[pro50]

Half way there on saving money for cams! sold my V&H fuel pack to jirvin yesterday. thanks and enjoy jeff.

[krcampbell]

Change the damn cams already Todd and quit talking about it

I encourage Todd to do all this stuff to his bike, then once he has done it he can help me do mine if I like it. lol

[pro50]

get to work, i know you have something to do........lol

[DevilDog]

Pro50 you will have to make a video when you get the cams in. I can't wait to hear what it sounds like.

[pro50]

i will definately do that! wish i knew someone with them already so i could hear them